Programming trouble-diagnosis

Programming trouble-diagnosis - HomeLink universal transceiver (Type A) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

If the HomeLink does not quickly learn the handheld transmitter information:

● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink surface.
● press and hold both the HomeLink and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.

If you continue to have programming difficulties, please contact the INFINITI Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.

    See also:

    Rear display settings
    To adjust the rear display settings, select the preferred key and press the ENTER button. The following settings are available: Aspect: Select the display size from “CINEMA”, “WIDE”, “FULL” or “NOR ...

    SNOW mode switch
    For driving or starting the vehicle on snowy roads or slippery areas, push on the SNOW mode switch. The SNOW mode indicator light will illuminate. When the SNOW mode is activated, engine out ...

    Washing
    Wash dirt off the vehicle with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, ...