Reprogramming a single HomeLink button

Reprogramming a single HomeLink button - HomeLink universal transceiver (Type A) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

To reprogram a HomeLink Universal Transceiver button, complete the following.

1. Press and hold the desired HomeLink button.

Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.

The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.

    See also:

    Cockpit
    1. Vehicle Dynamic Control (VDC) OFF switch2. Trunk lid release switch3. Sonar system off switch (if so equipped)4. Instrument brightness control switch5. TRIP/RESET switch for twin trip odometer6. ...

    Forward-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a forwardfacing child restraint usin ...

    Safety Shield
    For the 2011-model year M Line, Infiniti's 360-degree "bubble of protection" around the car known as the Safety Shield becomes more complete than ever. New features such as Blind Spot In ...