Clearing the programmed information

Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).
See also:
4WD shift indicator
The 4WD shift indicator is displayed in the
vehicle information display.
The indicator should turn off within 1
second after placing the ignition switch in
the ON position.
While the engin ...
Radar maintenance
The two radar sensors for the BSW, BSI and BCI systems are located near the rear bumper. Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient con ...
Liftgate position setting
The liftgate can be set to open to a specific height by performing the following:
1. Open the liftgate using the request switch or the Intelligent Key.
2. Pull the liftgate down to the desired p ...
