Automatic door locks

► All doors lock automatically when the
vehicle speed reaches 15 MPH (24
km/h).
► All doors unlock automatically when the
ignition switch is placed in the OFF
position.
The automatic unlock function can be
deactivated or activated. To deactivate or
activate the automatic door unlock system,
perform the following procedure:
1. Close all doors.
2. Place the ignition switch in the ON
position.
3. Within 20 seconds of performing Step
2, push and hold the power door lock
switch to the
position (UNLOCK) for
more than 5 seconds.
4. When activated, the hazard indicator
will flash twice. When deactivated, the
hazard indicator will flash once.
5. The ignition switch must be placed in
the OFF and ON position again between
each setting change.
When the automatic door unlock system is
deactivated, the doors do not unlock when
the ignition switch is placed in the OFF
position. To unlock the door manually, use
the inside lock knob or the power door lock
switch (driver’s or front passenger’s side).
See also:
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold temperature starting.
The engine block heater should be used when the outside temperature is 20°F (27°C) or lower.
WARNING
● Do not use y ...
USB memory operation
Audio main operation
Open the tray lid and connect a USB
memory 1 as illustrated. Then, push the
DISC·AUX button repeatedly to switch to
the USB memory mode.
If the system has been turned o ...
Linking the keyfob to automatic drivepositioner memory
If the vehicle is equipped with automatic drive positioner, the keyfob can be linked to a memory setting.
See “Automatic drive positioner” in this section. ...
