Seat belt maintenance
• To clean the seat belt webbing, apply a mild soap solution or any solution recommended for cleaning upholstery or carpets. Then, wipe with a cloth and allow the seat belts to dry in the shade.
Do not allow the seat belts to retract until they are completely dry.
• If dirt builds up in the shoulder belt guide of the seat belt anchors, the seat belts may retract slowly. Wipe the shoulder belt guide with a clean, dry cloth.
• Periodically check to see that the seat belt and the metal components such as buckles, tongues, retractors, flexible wires and anchors work properly. If loose parts, deterioration, cuts or other damage on the webbing is found, the entire seat belt assembly should be replaced.
See also:
Accelerator downshift — In D (Drive) position
For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into the lower gear, depending on the vehicle speed. ...
If your vehicle overheats
CAUTION
► Do not continue to drive if your vehicle
overheats. Doing so could cause engine
damage or a vehicle fire.
► To avoid the danger of being scalded,
never remove the rad ...
Rear-facing child restraint installation using the
seat belts
WARNING
The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being pro ...