To protect your vehicle from corrosion

To protect your vehicle from corrosion  - Corrosion protection - Appearance and care - Infiniti G Owners Manual - Infiniti G

• Wash and wax your vehicle often to keep the vehicle clean.

• Always check for minor damage to the paint and repair it as soon as possible.

• Keep drain holes at the bottom of the doors open to avoid water accumulation.

• Check the underbody for accumulation of sand, dirt or salt. If present, wash with water as soon as possible.

CAUTION
• NEVER remove dirt, sand or other debris from the passenger compartment by washing it out with a hose. Remove dirt with a vacuum cleaner.
• Never allow water or other liquids to come in contact with electronic components inside the vehicle as this may damage them.

Chemicals used for road surface deicing are extremely corrosive. They accelerate corrosion and deterioration of underbody components such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders.

In winter, the underbody must be cleaned periodically.

For additional protection against rust and corrosion, which may be required in some areas, consult an INFINITI retailer.

    See also:

    Vehicle load capacity
    Do not exceed the load limit of your vehicle shown as “The combined weight of occupants and cargo” on the Tire and Loading Information label. Do not exceed the number of occupants shown as ...

    Engine block heater (for Canada only)
    Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (−78°C) or lower. To use the engine block heat ...

    Starting the engine
    1. Apply the parking brake. 2. Move the selector lever to the P (Park) or N (Neutral) position. (P is recommended.). The starter is designed not to operate unless the selector lever is in eith ...