Remote starting the vehicle

Remote starting the vehicle - Remote Engine Start (if so equipped) - Pre-driving checks and adjustments - Infiniti JX Owners Manual - Infiniti JX

perform the following:

1. Aim the Intelligent Key at the vehicle.
2. Press all doors. the LOCK button to lock all doors.
3. Within 5 seconds press and hold the signal lights illuminate. If the vehicle is not within view press and hold the remote start remote start button until the turn signal lights illuminate. If the vehicle is not within view press and hold the button for about 2 seconds. remote start button for about 2 seconds.

The following events will occur when the engine starts:

● The parking lights will turn on and remain on as long as the engine is running.
● The doors will be locked and the climate control system may come on.
● The engine will continue to run for 10 minutes.

Repeat the steps to extend the time for an additional 10 minutes. See “Extending engine run time” in this section.

Depress the brake and place the ignition switch in the ON position before driving. For further instructions see “Driving the vehicle” in the “Starting and driving” section.

    See also:

    Engine block heater (if so equipped)
    Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine bloc ...

    Rocking a stuck vehicle
    If your vehicle is stuck in sand, snow, mud, etc., use the following procedure: 1. Turn off the Vehicle Dynamic Control (VDC) system. 2. Make sure the area in front and behind the vehicle is clear of ...

    View malfunction
    When the “!” icon is displayed on the screen, there will be abnormal conditions in the around view monitor. This will not hinder normal driving operation but the system should be inspected by an INF ...