Liftgate position setting

Liftgate position setting  - Liftgate - Pre-driving checks and adjustments - Infiniti JX Owners Manual - Infiniti JX

The liftgate can be set to open to a specific height by performing the following:

1. Open the liftgate using the request switch or the Intelligent Key.
2. Pull the liftgate down to the desired position and hold the liftgate (the liftgate will have some resistance when being manually adjusted).
3. While holding the liftgate in position, press and hold the liftgate switch located on the liftgate for approximately 5 seconds or until 3 beeps are heard. located on the liftgate for approximately 5 seconds or until 3 beeps are heard.

The liftgate will open to the selected position setting. To change the position of the liftgate, repeat steps 1-3 for setting the position of the liftgate.

    See also:

    Exterior and interior lights
    Sedan *: See an INFINITI retailer for replacement.NOTE: Always check with the Parts Department at an INFINITI retailer for the latest information about parts. Coupe *: See an INFINITI retaile ...

    Vehicle Identification Number (VIN) plate
    Vehicle Identification Number (VIN) plate The vehicle identification number plate is attached as shown. This number is the identification for your vehicle and is used in the vehicle registration. ...

    Air conditioning system refrigerant and lubricant recommendations
    The air conditioning system in your INFINITI vehicle must be charged with the refrigerant HFC-134a (R-134a) and the lubricant, NISSAN A/C system oil Type S or the exact equivalents. CAUTION The use ...