Operating vehicle-to-vehicle distancecontrol mode

Operating vehicle-to-vehicle distancecontrol mode - Vehicle-to-vehicle distance control mode operation - Intelligent cruise control (ICC) system (Full Speed Range) (if so equipped) - Starting and driving - Infiniti JX Owners Manual - Infiniti JX

To turn on the cruise control, quickly push and release the CRUISE ON/OFF switch A on.

To turn on the cruise control, quickly push and release the CRUISE ON/OFF switch A on.

The cruise indicator light, set distance indicator and set vehicle speed indicator come on and in a standby state for setting.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator B will come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator B will come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

When the COAST/SET switch is pushed under the following conditions, the system cannot be set and the cancellation message will pop up.

● When traveling below 20 MPH (32 km/h) and the vehicle ahead is not detected
● When the shift selector not in the D (Drive) or Manual mode
● When the windshield wipers are operating at low (LO) or high speed (HI). If the vehicle is equipped with a rain-sensing auto wiper, the system may cancel when the wipers are operating at the intermittent (INT) or AUTO speed.

● When the parking brake is applied
● When the brakes are operated by the driver When the COAST/SET switch is pushed under the following conditions, the system cannot be set.

A warning chime will sound and a message will pop up.

● When the SNOW mode switch is ON (To use the ICC system, turn off the SNOW mode switch, push the CRUISE ON/OFF switch to turn off the ICC and reset the ICC switch by pressing the CRUISE ON/OFF switch again.) For details about the SNOW mode switch, see “Snow mode switch” in this section.
● When the VDC system is off (To use the ICC system, turn on the VDC system. Push the CRUISE ON/OFF switch to turn off the ICC system and reset the ICC switch by pushing the CRUISE ON/OFF switch again.) For details about the VDC system, see “Vehicle Dynamic Control (VDC) system” in this section.
● When ABS or VDC (including the traction control system) is operating
● When a wheel is slipping (To use the ICC system, make sure the wheels are no longer slipping. Push the CRUISE ON/OFF switch to turn off the ICC, and reset the ICC system by pushing the CRUISE ON/OFF switch again.)

    See also:

    Operating tips
    ► The images from a device that is connected to the rear auxiliary input jacks cannot be viewed on the front displays. ► It is not possible to switch the source to USB (if so equ ...

    Air fresheners
    Most air fresheners use a solvent that could affect the vehicle interior. If you use an air freshener, take the following precautions: ► Hanging-type air fresheners can cause permanent d ...

    Pregnant women
    INFINITI recommends that pregnant women use seat belts. The seat belt should be worn snug, and always position the lap belt as low as possible around the hips, not the waist, and place the s ...