Sensor maintenance

Sensor maintenance - Vehicle-to-vehicle distance control mode operation - Intelligent cruise control (ICC) system (Full Speed Range) (if so equipped) - Starting and driving - Infiniti JX Owners Manual - Infiniti JX

The sensor for the ICC system A is located below the front bumper.

The sensor for the ICC system A is located below the front bumper.

To keep the ICC system operating properly, be sure to observe the following:

● Always keep the sensor clean. Wipe with a soft cloth carefully so as not to damage the sensor.
● Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on the sensor. Doing so could cause failure or malfunction. If the sensor is damaged due to an accident, contact an INFINITI retailer.
● Do not cover or attach stickers or similar objects on the front bumper near the sensor area. This could cause failure or malfunction.
● Do not attach metallic objects near the sensor area (kangaroo bars, etc.) This could cause failure or malfunction.
● Do not alter, remove, or paint the front bumper.

Before customizing or restoring the front bumper, please contact an INFINITI retailer.

    See also:

    Standard mode
    Recommended for normal driving. Turn the drive mode select switch to the center position. “STANDARD” appears in the vehicle information display for 2 seconds. ...

    Booster seats
    Precautions on booster seats WARNING If a booster seat and seat belt are not used properly, the risk of a child being injured in a sudden stop or collision greatly increases: – Make sure the sh ...

    INFINITI vehicle immobilizer system
    The INFINITI Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interferenc ...