Intelligent Cruise Control (ICC) system (if so equipped)

Intelligent Cruise Control (ICC) system (if so equipped)  - Starting and driving - Infiniti QX Owners Manual - Infiniti QX

The Intelligent Cruise Control (ICC) system automatically maintains a selected distance from the vehicle traveling in front of you according to that vehicle’s speed (up to the set speed), or at the set speed when the road ahead is clear. The ICC function can be set to one of two cruise control modes:
► Vehicle-to-vehicle distance control mode: For maintaining a selected distance between your vehicle and the vehicle in front of you up to the preset speed.
► Conventional (fixed speed) cruise control mode: For cruising at a preset speed.

► Always drive carefully and attentively WARNING

► Always drive carefully and attentively when using either cruise control mode. Read and understand the Owner’s Manual thoroughly before using the ICC system. To avoid serious injury or death, do not rely on the system to prevent accidents or to control the vehicle’s speed in emergency situations. Do not use the ICC system except in appropriate road and traffic conditions.
► In the conventional (fixed speed) cruise control mode, a warning chime will not sound to warn you if you are too close to the vehicle ahead. Pay special attention to the distance between your vehicle and the vehicle ahead of you or a collision could occur.

1. Vehicle-to-vehicle distance control

1. Vehicle-to-vehicle distance control mode
2. Conventional (fixed speed) cruise control mode

Push the MAIN switch A to choose the cruise control mode between the vehicleto- vehicle distance control mode 1 and the conventional (fixed speed) cruise control mode 2 . To choose the vehicle-to-vehicle distance control mode1 , quickly push and release the MAIN switch A . To choose the conventional (fixed speed) cruise control mode 2 , push and hold the MAIN switch A for longer than approximately 1.5 seconds. Once a control mode is activated, it cannot be changed to the other cruise control mode. To change the mode, push the MAIN switch once to turn the system off. Then push the MAIN switch again to turn the system back on and select the desired cruise control mode. Always confirm the setting in the ICC system display. For the vehicle-to-vehicle distance control mode, see the following description. For the conventional (fixed speed) cruise con trol mode, see “Conventional (fixed speed) cruise control mode” later in this section.

See also:

System maintenance
► The two radar sensor units 1 for the BSW and Blind Spot InterventionTM systems are located near the rear bumper. Always keep the area near the radar sensors clean. Do not attach st ...

Tow mode switch
TOW MODE should be used when pulling a heavy trailer or hauling a heavy load. Driving the vehicle in TOW MODE with no trailer/load or light trailer/light load will not cause any damage. Howe ...

Luggage hooks
WARNING ► Always make sure that the cargo is properly secured. Use the suitable ropes and hooks. ► Unsecured cargo can become dangerous in an accident or sudden stop. ► ...