Checking bulbs

Checking bulbs - Warning/indicator lights and audible reminders - Instruments and controls - Infiniti G Owners Manual - Infiniti G

With all doors closed, apply the parking brake and push the ignition switch to the ON position without starting the engine.

The following lights will come on (if so equipped):

The following lights come on briefly and then go off (if so equipped):

The following lights come on briefly and then go off (if so equipped):

If any light does not come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system checked by an INFINITI retailer.

If any light does not come on, it may indicate a burned-out bulb or an open circuit in the electrical system. Have the system checked by an INFINITI retailer.

Some indicators and warnings are also displayed on the dot matrix crystal display between the speedometer and tachometer.

(See “Dot matrix liquid crystal display”.)

    See also:

    Engine block heater (if so equipped)
    Engine block heaters are used to assist with cold temperature starting. The engine block heater should be used when the outside temperature is 20°F (27°C) or lower. WARNING ● Do not use y ...

    Temperature A, B and C
    The temperature grades A (the highest), B, and C, representing the tire’s resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a sp ...

    Fuel gauge
    The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to 0 (Emp ...