Interior light control switch


Interior light control switch
The interior light control switch has three positions: ON, DOOR and OFF.
ON position
When the switch is in the ON position 1 the map lights and rear personal lights will illuminate.
DOOR position
When the switch is in the DOOR position 2 , the map lights and rear personal lights will illuminate under the following conditions: . ignition switch is switched to the LOCK position — remain on for about 15 seconds.
• doors are unlocked by pushing the UNLOCK button on the Intelligent Key or door handle request switch with the ignition switch in the LOCK position — remain on for about 15 seconds.
• any door is opened and then closed with the ignition switch in the LOCK position — remain on for about 15 seconds.
• any door is opened with the ignition switch in the ACC or ON position — remain on while the door is opened.
When the door is closed, the lights go off.
The lights will also turn off after 15 minutes when the lights remain illuminated after the ignition switch has been pushed to the OFF or LOCK position to prevent the battery from becoming discharged.
When the auto interior illumination is set to the OFF position (see “Vehicle information and settings”), the lights will illuminate under the following condition:
• any door is opened with the ignition switch in any position — remain on while the door is opened.
When the door is closed, the lights go off.
OFF position
When the switch is in the OFF position 3 , the lights will not illuminate, regardless of the condition.
CAUTION
Do not use for extended periods of time with the engine stopped. This could result in a discharged battery.
See also:
When traveling or registering your vehicle inanother country
If you plan to travel in another country,
you should first find out if the fuel
available is suitable for your vehicle’s
engine.
Using fuel with too low an octane rating
may cause engine dam ...
Using the system
Depress the brake pedal and hold it down.
Depress the brake pedal with firm steady pressure, but do not pump the brakes. The ABS will operate to prevent the wheels from locking up. Steer the vehicle ...
Replacing
Replace the wiper blades if they are worn.
1. Lift the wiper arm away from the windshield.
2 Push the release tab, then move the wiper blade down the wiper arm to remove.
3 Remove the wiper ...
