Cancel or activate seat synchronization function

Cancel or activate seat synchronization function - Seat synchronization function - Automatic drive positioner (if so equipped) - Pre-driving checks and adjustments - Infiniti G Owners Manual - Infiniti G

For Automatic Transmission models: The selector lever must be in the P (Park) position with the ignition switch in the ACC position.

For Manual Transmission models: The parking brake must be applied with the ignition switch in the ACC position.

The seat synchronization function can be activated or canceled by pushing and holding the SET switch for more than 10 seconds while the ignition switch is in the ACC position.

The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pushed for more than 10 seconds to turn on or off the seat synchronization function.

    See also:

    Approach warning
    If your vehicle comes closer to the vehicle ahead due to rapid deceleration of that vehicle or if another vehicle cuts in, the system warns the driver with the chime and ICC system display. Deceler ...

    Clearing the programmed information
    Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING ► If stopping for an emergency, be sure to ...