IC Regulatory information

• Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
• This Class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.
Bluetooth trademark:

See also:
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to fl ...
Entering from the side
The Blind spot warning indicator light illuminates if a vehicle enters the detection zone from either side.
NOTE:
The radar sensors may not detect a vehicle which is traveling at about the same sp ...
Snow mode
Used on snowy roads or slippery areas. When the SNOW mode is activated, engine output is controlled to avoid wheel spin. Turn the SNOW mode off for normal driving. Turn the drive mode select switch to ...
