INFINITI Voice Recognition system (models with navigation system)
INFINITI Voice Recognition allows handsfree operation of the Phone, Navigation, Information and Audio systems in one of two modes, Standard Mode or Alternate Command Mode.
In Standard Mode, commands that are available are always shown on the display and announced by the system. You can complete your desired operation by simply following the prompts given by the system.
(See “INFINITI Voice Recognition STANDARD mode” for details.) For advanced operation, you can use the Alternate Command Mode. (See “INFINITI Voice Recognition alternate command mode” for details.) When this mode is active, an expanded list of commands can be spoken after pushing the TALK switch, and the voice command menu prompts are turned off.
Review the expanded command list, which is available when this mode is active. Note that in this mode the recognition success rate may be affected as the number of available commands and the ways of speaking each command are increased.
To switch one mode to another, see each mode description later in this section.
To improve the recognition success rate when Alternate Command Mode is active, try using the Speaker Adaptation Function available in that mode. Otherwise, it is recommended that Alternate Command Mode be turned off and Standard Mode be used for the best recognition performance.
For the voice commands for the navigation system, refer to the Navigation System Owner’s Manual of your vehicle.
See also:
Ventilators
Center ventilators
Side ventilators
Rear (if so equipped)
Open or close, and adjust the air flow direction of ventilators.
: This
symbol indicates that the vents are closed.
: This
sy ...
Preview function (Intelligent Cruise Control system equipped models)
When the Preview Function identifies the need to apply emergency braking by sensing a vehicle ahead in the same lane and the distance and relative speed from it, it applies the brake pre-pressure befo ...
All-Wheel Drive (AWD) (if so equipped)
All-Wheel Drive (AWD) (if so equipped)
The AWD warning light is located in the meter.
The AWD warning light comes on when the ignition switch is pushed to the ON position. It turns off soon after ...