Operating vehicle-to-vehicle distance control mode

Operating vehicle-to-vehicle distance control mode - Vehicle-to-vehicle distance control mode operation - Intelligent Cruise Control (ICC) system (if so equipped) - Starting and driving - Infiniti G Owners Manual - Infiniti G

Operating vehicle-to-vehicle distance control mode
Operating vehicle-to-vehicle distance control mode

To turn on the cruise control, quickly push and release the MAIN switch A on. The cruise indicator light, set distance indicator and set vehicle speed indicator come on and in a standby state for setting.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

When the COAST/SET switch is pushed under the following conditions, the system cannot be set and the ICC indicators will blink for approximately 2 seconds: . When traveling below 25 MPH (40 km/h) and the vehicle ahead is not detected• When the selector lever is not in the D, DS or Manual mode• When the windshield wipers are operating at low (LO) or high speed (HI).• When the brakes are operated by the driver

When the COAST/SET switch is pushed under the following conditions, the system cannot be set and the ICC indicators will blink for approximately 2 seconds: . When traveling below 25 MPH (40 km/h) and the vehicle ahead is not detected
• When the selector lever is not in the D, DS or Manual mode
• When the windshield wipers are operating at low (LO) or high speed (HI).
• When the brakes are operated by the driver

When the COAST/SET switch is pushed under the following conditions, the system cannot be set.

When the COAST/SET switch is pushed under the following conditions, the system cannot be set.

A warning chime will sound and the ICC indicators will blink.

• When the SNOW mode switch is ON (To use the ICC system, turn off the SNOW mode switch, push the MAIN switch to turn off the ICC and reset the ICC switch by pressing the MAIN switch again.) For details about the SNOW mode switch, see “SNOW mode switch”.

1. System set display with vehicle ahead2. System set display without vehicle ahead

1. System set display with vehicle ahead
2. System set display without vehicle ahead

    See also:

    HomeLink® Universal Transceiver (if so equipped)
    HomeLink® Universal Transceiver provides a convenient way to consolidate the functions of up to three individual hand-held transmitters into one built-in device. HomeLink® Universal Transceiver: . Wi ...

    USB input operation (if so equipped)
    USB input operation (if so equipped) Audio main operation Open the console lid and connect a USB memory 1 as illustrated. Then, push the DISC·AUX or AUX button repeatedly to switch to the USB memo ...

    Lower Anchors and Tethers for CHildren System (LATCH)
    LATCH system lower anchor locations - captain’s seats LATCH system lower anchor locations - bench seat Your vehicle is equipped with special anchor points that are used with the LATC ...