Vehicle set-up

Vehicle set-up - Changing engine oil and filter - Engine oil - Maintenance and do-it-yourself - Infiniti G Owners Manual - Infiniti G

1. Park the vehicle on a level surface and apply the parking brake.

2. Run the engine until it reaches operating temperature.

3. Turn the engine off and wait more than 15 minutes.

4. Raise and support the vehicle using a suitable floor jack and safety jack stands.

• Place the safety jack stands under the vehicle jack-up points.

• A suitable adapter should be attached to the jack stand saddle.

5. Remove the plastic engine undercover.

a. Remove the small plastic clip at the center point of the undercover.

b. Then remove the other bolts that hold the undercover in place.

CAUTION
Make sure the correct lifting and support points are used to avoid vehicle damage.

    See also:

    Programming trouble-diagnosis
    If the HomeLink does not quickly learn the handheld transmitter information: ● replace the hand-held transmitter batteries with new batteries. ● position the hand-held transmitter wi ...

    Tilt/telescopic steering
    WARNING • Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accident.• Do not adjust the steering wheel any closer to you than is necessary for prope ...

    HomeLink universal transceiver (Type B) (if so equipped)
    The Type B system can be identified by the IV 1 on the back of the mirror. Move the mirror to see if the IV is present. If the IV is on the mirror, use the procedure in this section to program the H ...