Switch operation
The windshield wiper and washer operates when the ignition switch is in the ON position.
Push the lever down to operate the wiper at the following speed:
1 Intermittent (INT) — intermittent operation can be adjusted by turning the knob toward A (Slower) or B (Faster). Also, the intermittent operation speed varies in accordance with the vehicle speed. (For example, when the vehicle speed is high, the intermittent operation speed will be faster.)
NOTE:
You can turn on or turn off the driving speed dependent intermittent wiper function.
Refer to “Vehicle information display” in this section.
For models with the rain-sensing auto wiper system, see “Rain-sensing auto wiper system” in this section.
2 Low (LO)—continuous low speed operation
3 High (HI) — continuous high speed operation
Push the lever up 4 to have one sweep operation (MIST) of the wiper.
Pull the lever toward you 5 to operate the washer. The wiper will also operate several times.
See also:
VQ37VHR engine
Use unleaded premium gasoline with an octane rating of at least 91 AKI (Anti-Knock Index) number (Research octane number 96).
If premium gasoline is not available, unleaded regular gasoline with an o ...
Freeing a frozen door lock
To prevent a door lock from freezing, apply
deicer through the key hole. If the lock
becomes frozen, heat the key before
inserting it into the key hole or use the
Intelligent Key system. ...
Sensor maintenance
The sensor for the ICC system A is located below the front bumper.
To keep the ICC system operating properly, be sure to observe the following:
● Always keep the sensor clean. Wipe with ...