Turn signal switch


Turn signal
1 Move the lever up or down to signal the turning direction. When the turn is completed, the turn signals cancel automatically
Lane change signal
2 To signal a lane change, move the lever up or down to the point where the indicator light begins to flash, but the lever does not latch.
See also:
Brake force distribution
During braking while driving through turns, the system optimizes the distribution of force to each of the four wheels depending on the radius of the turn.
WARNING
● The VDC system is designe ...
Emission control information label
The emission control information label is
attached as shown. ...
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold temperature starting.
The engine block heater should be used when the outside temperature is 20°F (27°C) or lower.
WARNING
● Do not use y ...
