Programming HomeLink for Canadian customers

Programming HomeLink for Canadian customers - HomeLink universal transceiver (Type A) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

Prior to 1992, D.O.C. regulations required handheld transmitters to stop transmitting after 2 seconds.

To program your hand-held transmitter to HomeLink , continue to press and hold the HomeLink button (see steps 2 - 4 under “Programming HomeLink ”) while you press and repress (“cycle”) your hand-held transmitters every 2 seconds until the indicator light flashes rapidly (indicating successful programming).

NOTE:
When programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

    See also:

    Sensor maintenance
    The sensor for the ICC system A is located below the front bumper. To keep the ICC system operating properly, be sure to observe the following: ● Always keep the sensor clean. Wipe with ...

    Headlight control switch
    Lighting 1 When turning the switch to the position, the front parking, tail, license plate and instrument panel lights come on. 2 When turning the switch to the position, the headlights co ...

    INFINITI Intelligent Key battery discharge
    If the battery of the Intelligent Key is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Place the sh ...