Reprogramming a single HomeLink button

Reprogramming a single HomeLink button - HomeLink universal transceiver (Type A) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

To reprogram a HomeLink Universal Transceiver button, complete the following.

1. Press and hold the desired HomeLink button.

Do not release the button until step 4 has been completed.
2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface.
3. Press and hold the hand-held transmitter button.
4. The HomeLink indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.

The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.

    See also:

    Lane Departure Warning (LDW) system/ Lane Departure Prevention (LDP) system (if so equipped)
    The Lane Departure Warning (LDW) system/ Lane Departure Prevention (LDP) system will operate when the vehicle is driven at speeds of approximately 45 MPH (70 km/h) and above, and when it is travelin ...

    Increasing fuel economy
    • Accelerate slowly and smoothly. Maintain cruising speeds with a constant accelerator position. • Drive at moderate speeds on the highway. • Avoid unnecessary stopping and braking. Keep a safe dis ...

    INFINITI Voice Recognition Standard Mode
    The following section is applicable when the Standard Mode is activated. The Standard Mode enables you to complete the desired operation by simply following the prompts that appear on the di ...