Programming HomeLink

Programming HomeLink  - HomeLink universal transceiver (Type B) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

If you have any questions or are having difficulty programming your HomeLink buttons, refer to the HomeLink web site at: www.homelink.com or call 1-800-355-3515.

NOTE:
Place the ignition switch in the ACC position when programming HomeLink . It is also recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink for quicker programming and accurate transmission of the radio-frequency.

1. Position the end of your hand-held transmitter 1–3 inches (5–14 cm) away from the HomeLink surface, keeping the HomeLink indicator light in view.

2. Using both hands, simultaneously press and hold the desired HomeLink button and handheld transmitter button. DO NOT release until the HomeLink indicator light flashes 1 slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful training.)

2. Using both hands, simultaneously press and hold the desired HomeLink button and handheld transmitter button. DO NOT release until the HomeLink indicator light flashes 1 slowly and then rapidly. When the indicator light flashes rapidly, both buttons may be released. (The rapid flashing indicates successful training.)

NOTE:
Some devices may require you to replace Step 2 with the cycling procedure noted in the “Programing HomeLink for Canadian customers and gate openers” section.

3. Press and hold the trained HomeLink button and observe the indicator light.

3. Press and hold the trained HomeLink button and observe the indicator light.

● If the indicator light 1 is solid/ continuous, training is complete and your device should activate when the HomeLink button is pressed and released.
● If the indicator light 1 blinks rapidly for two seconds and then turns to a solid/continuous light, continue with Steps 4-6 for a rolling code device.

A second person may make the following steps easier. Please use a ladder or other device. Do not stand on your vehicle to perform the next steps.

4. At the receiver (motorhead unit) in the garage, locate the “learn” or “smart” button (usually near where the hanging antenna wire is attached to the unit). If there is difficulty locating the button, reference the garage door opener’s manual.
5. Press and release the “learn” or “smart” button (the name and color of the button may vary by manufacturer.) NOTE: Once the button is pressed, you have approximately 30 seconds to initiate the next step.
6. Return to the vehicle and firmly press and hold the trained HomeLink button for two seconds and release. Repeat the “press/hold/release” sequence up to 3 times to complete the training process.

HomeLink should now activate your rolling code equipped device.
7. If you have any questions or are having difficulty programming your HomeLink buttons, refer to the HomeLink web site at:

www.homelink.com or call 1-800-355-3515.

    See also:

    2009 Infiniti M35 Review
    A sedan isn't usually what comes to mind when you think of a family car, but the 2009 Infiniti M35x could change that. The M35x single-handedly proves that sedans can be great family cars. In fact ...

    Installing front license plate
    Use the following steps to mount the front license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag: Only use the recommended mounting ...

    Battery
    If the battery is not fully charged during extremely cold weather conditions, the battery fluid may freeze and damage the battery. To maintain maximum efficiency, the battery should be checked regular ...