Extending engine run time
time by performing the steps listed in “Remote starting the vehicle” in this section. Run time will be calculated as follows:
● The first 10 minute run time will start when the remote start function is performed.
● The second 10 minutes will start immediately when the remote start function is performed.
For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles.
The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again.
See also:
Tire Pressure Monitoring System (TPMS)
This vehicle is equipped with the Tire
Pressure Monitoring System (TPMS). It
monitors tire pressure of all tires except
the spare. When the low tire pressure
warning light is lit and the CHECK ...
Automatic cancellation
A chime sounds under the following conditions and the control is automatically canceled.
• When the vehicle slows down more than 8 MPH (13 km/h) below the set speed . When the vehicle speed falls bel ...
Locking with power door lock switch
To lock all the doors without a key, push the door lock switch (driver’s or front passenger’s side) to the lock position 1 . When locking the door this way, be certain not to leave the key inside th ...