Entry/exit function
This system is designed so that the driver’s seat and automatic operation steering column will automatically move when the shift selector is in the P (Park) position. This allows the driver to get into and out of the driver’s seat more easily.
The driver’s seat will slide backward and the steering column will move up:
● When the driver’s door is opened with the ignition switch placed in the LOCK position.
● When the ignition switch is turned from ACC to LOCK with the driver’s door open.
The driver’s seat and steering wheel will return to the previous position:
● When the driver’s door is closed with the ignition switch placed in the LOCK position.
● When the ignition switch is turned from ACC toONwhile the shift selector is in the P (Park) position.
The entry/exit function can be adjusted or canceled through the Vehicle Settings in the vehicle information display by performing the following:
● Switch the Exit Seat Slide from ON to OFF.
● Switch the Exit Steering UP from ON to OFF.
Restarting the entry/exit function
If the battery cable is disconnected or if the fuse opens, the entry/exit function will be disabled.
Drive the vehicle over 25 MPH (40 km/h) to restart the entry/exit function. You can also restart the entry/exit function using the following procedure.
1. Connect the battery cable or replace the fuse.
2. Open and close the driver’s door more than 2 times with the ignition switch in the LOCK position.
The entry/exit function should now work properly.
See also:
Automatic door locks
● All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
● All doors unlock automatically when the ignition is placed in the OFF position.
The automatic unlock f ...
LATCH lower anchor location
LATCH label locations 2nd row bench
The LATCH lower anchors are located at the rear of the seat cushion near the seatback. A label is attached to the seatback to help you locate the LATCH lower an ...
Seat belts with pretensioners (front seats)
WARNING
• The pretensioners cannot be reused after activation. They must be replaced together with the retractor and buckle as a unit.• If the vehicle becomes involved in a collision but a pretension ...