Operating vehicle-to-vehicle distancecontrol mode

Operating vehicle-to-vehicle distancecontrol mode  - Vehicle-to-vehicle distance control mode operation - Intelligent cruise control (ICC) system (Full Speed Range) (if so equipped) - Starting and driving - Infiniti JX Owners Manual - Infiniti JX

To turn on the cruise control, quickly push and release the CRUISE ON/OFF switch A on.

To turn on the cruise control, quickly push and release the CRUISE ON/OFF switch A on.

The cruise indicator light, set distance indicator and set vehicle speed indicator come on and in a standby state for setting.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator B will come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

To set cruising speed, accelerate your vehicle to the desired speed, push the COAST/SET switch and release it. (Vehicle ahead detection indicator, set distance indicator and set vehicle speed indicator B will come on.) Take your foot off the accelerator pedal. Your vehicle will maintain the set speed.

When the COAST/SET switch is pushed under the following conditions, the system cannot be set and the cancellation message will pop up.

● When traveling below 20 MPH (32 km/h) and the vehicle ahead is not detected
● When the shift selector not in the D (Drive) or Manual mode
● When the windshield wipers are operating at low (LO) or high speed (HI). If the vehicle is equipped with a rain-sensing auto wiper, the system may cancel when the wipers are operating at the intermittent (INT) or AUTO speed.

● When the parking brake is applied
● When the brakes are operated by the driver When the COAST/SET switch is pushed under the following conditions, the system cannot be set.

A warning chime will sound and a message will pop up.

● When the SNOW mode switch is ON (To use the ICC system, turn off the SNOW mode switch, push the CRUISE ON/OFF switch to turn off the ICC and reset the ICC switch by pressing the CRUISE ON/OFF switch again.) For details about the SNOW mode switch, see “Snow mode switch” in this section.
● When the VDC system is off (To use the ICC system, turn on the VDC system. Push the CRUISE ON/OFF switch to turn off the ICC system and reset the ICC switch by pushing the CRUISE ON/OFF switch again.) For details about the VDC system, see “Vehicle Dynamic Control (VDC) system” in this section.
● When ABS or VDC (including the traction control system) is operating
● When a wheel is slipping (To use the ICC system, make sure the wheels are no longer slipping. Push the CRUISE ON/OFF switch to turn off the ICC, and reset the ICC system by pushing the CRUISE ON/OFF switch again.)

    See also:

    Tilt/telescopic steering
    WARNING ● Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accident. ● Do not adjust the steering wheel any closer to you than is n ...

    Terms
    It is important to familiarize yourself with the following terms before loading your vehicle: ► Curb Weight (actual weight of your vehicle) - vehicle weight including: standard and opt ...

    Under the hood and vehicle
    The maintenance items listed here should be checked periodically (for example, each time you check the engine oil or refuel). Battery*: Check the fluid level in each cell. It should be between the M ...