Automatic cancellation
A chime sounds under the following conditions and the control is automatically canceled.
● When the vehicle ahead is not detected and your vehicle is traveling below the speed of 15 MPH (24 km/h)
● When the system judges the vehicle is at standstill
● When the shift selector is not in the D or Manual mode
● When the windshield wipers are operating at low (LO) or high speed (HI). If the vehicle is equipped with a rain sensing auto-wiper, the system may cancel when the wipers are set to intermittent (INT).
● When the parking brake is applied
● When the SNOW mode switch is turned
ON
● When the VDC system is turned off
● When ABS or VDC (including the traction control system) operates
● When distance measurement becomes impaired due to adhesion of dirt or obstruction to the sensor
● When a wheel slips
See also:
How to change the set vehicle speed
To cancel the preset speed, use any of these methods: . Push the CANCEL switch. The set vehicle speed indicator will go out.
• Tap the brake pedal. The set vehicle speed indicator will go out.
• Tur ...
Rain-sensing auto wiper system (if so equipped)
Rain-sensing auto wiper system (if so equipped)
The rain-sensing auto wiper system can automatically turn on the wipers and adjust the wiper speed depending on the rainfall and the vehicle speed by ...
Vehicle Dynamic Control (VDC) OFF switch
The vehicle should be driven with the
Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the
VDC system reduces the engine output to ...