Meter/ring illumination and needle sweep

Infiniti QX / Infiniti QX Owners Manual / Instruments and controls / Meters and gauges / Meter/ring illumination and needle sweep

Meter/ring illumination and needle sweep - Meters and gauges - Instruments and controls - Infiniti QX Owners Manual - Infiniti QX

The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is started, the indicator needles will sweep in the speedometer and tachometer and the ring illumination will be brightened gradually. This function can be turned off. (See “Trip computer” later in this section.)

    See also:

    Getting the spare tire and tools
    Jacking tools — Sedan Jacking tools — Coupe Spare — Sedan and Coupe Raise the trunk floor cover 1 using the tab A . Remove jacking tools located inside the trunk as illustrated. The spare t ...

    Clearing the programmed information
    Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds). ...

    INFINITI Voice Recognition Standard Mode
    The Standard Mode enables control of navigation, phone and vehicle information. With this setting active, commands that are available are always shown on the display and announced by the system. Disp ...