Reprogramming a single HomeLink® button
To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. 3. Push and hold the hand-held transmitter button. 4. The HomeLink® indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.
See also:
Vehicle phonebook
This vehicle has two phonebooks available
for hands-free use. Depending on the
phone, the system may automatically
download the entire cell phone’s phonebook
into the “Handset Phonebook”. For ...
Intelligent Key system
WARNING
• Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before use.• ...
Top tether anchor point locations
Anchor points are located on the rear parcel shelf.
The child restraint top tether strap must be used when installing the child restraint with the LATCH lower anchor attachments or seat belts. See “I ...