Memory storage
Two positions for the driver’s seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Move the selector lever to the P (Park) position. 2. Push the ignition switch to the ON position. 3. Adjust the driver’s seat, steering column and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see “Seats” in the “1. Safety — seats, seat belts and supplemental restraint system” section and “Tilt/ telescopic steering” earlier in this section and “Outside mirrors” earlier in this section. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will stay on for approximately 5 seconds after pushing the switch. If memory is stored in the same memory switch, the previous memory will be deleted.
Linking Intelligent Key to a stored memory position
The Intelligent Key can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds, push the button on the Intelligent Key. If the indicator light blinks, the Intelligent Key is linked to that memory setting. Push the ignition switch to the OFF position, and then push the button on the Intelligent Key. The driver’s seat, steering wheel and outside mirrors will move to the memorized position. Confirming memory storage
► Push the ignition switch to the ON
position and push the SET switch. If
the main memory has not been stored,
the indicator light will come on for
approximately 0.5 second. When the
memory has stored in position, the indicator light will stay on for
approximately
5 seconds.
► If the battery cable is disconnected, or if
the fuse opens, the memory will be
canceled. In this case, reset the desired
position using the previous procedure.
► If optional Intelligent Keys are added to
your vehicle, the memory storage procedure
to switch 1 or 2 and linking
Intelligent Key procedure to a stored
memory position should be performed
again for each Intelligent Key. For
additional Intelligent Key information,
see “Keys” earlier in this section.
1. Move the selector lever to the P (Park) position. 2. Use one of the following methods to move the driver’s seat, the outside mirrors and the steering wheel.
► Push the ignition switch to the ON
position and push the memory
switch (1 or 2) fully for at least 1
second.
► Within 45 seconds of opening the
driver’s door, push the memory
switch (1 or 2) fully for at least 1
second.
The driver’s seat, steering column and
outside mirrors will move to the memorized
position or to the exit position
when the entry/exit function is set to
active with the indicator light flashing,
and then the light will stay on for
approximately 5 seconds.
See also:
BSW/Blind Spot InterventionTM malfunction
When the BSW/Blind Spot InterventionTM
systems malfunction, they will be turned
off automatically, a beep will sound and
the BSW/Blind Spot InterventionTM system
warning light (orange) will il ...
How to select menus on the screen
Vehicle functions are viewed on the center display screen in menus. Whenever a menu selection is made or menu item is highlighted, different areas on the screen provide you with important informatio ...
How to use STATUS button
To display the status of the audio, air
conditioner system, fuel consumption and
navigation system, push the STATUS button.
The following information will appear
when the STATUS button is push ...