System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
► When the vehicle speed is above 4 MPH
(7 km/h).
► When the adjusting switch for the
driver’s seat and steering column is
turned on while the automatic drive
positioner is operating.
► When the memory switch 1 or 2 is not
pushed for at least 1 second.
► When the seat, steering column and
outside mirrors have already been
moved to the memorized position.
► When no position is stored in the
memory switch.
► When the engine is started while
moving the automatic drive positioner.
► When the AT selector lever is moved
from the P (Park) position to any other
position. (However, it will not be
canceled if the switch is pushed while
the seat and steering column are
returning to the previous positions
(entry/exit function).).
► When the driver’s door remains open
for more than 45 seconds and the
ignition switch is not in the ON position.
See also:
Changing engine oil
1. Park the vehicle on a level surface and apply the parking brake.
2. Start the engine and let it idle until it reaches operating temperature, then turn it off.
3. Remove the oil filler cap A ...
Uniform tire quality grading
DOT (Department Of Transportation) Quality
Grades: All passenger car tires must
conform to federal safety requirements in
addition to these grades.
Quality grades can be found where applicable ...
SNOW mode switch (if so equipped)
SNOW mode switch (if so equipped)
For driving or starting the vehicle on snowy roads or slippery areas, turn on the SNOW mode switch. The indicator light
1 on the switch will illuminate. When the ...