Automatic door locks

• All doors lock automatically when the vehicle speed reaches 15 MPH (24 km/h).
• All doors unlock automatically when the ignition switch is placed in the OFF position.
The automatic unlock function can be deactivated or activated. To deactivate or activate the automatic door unlock system, perform the following procedure: 1. Close all doors.
2. Place the ignition switch in the ON position.
3. Within 20 seconds of performing Step 2, push and hold the power door lock switch to the
position (UNLOCK) for more than 5 seconds.
4. When activated, the hazard indicator will flash twice. When deactivated, the hazard indicator will flash once.
5. The ignition switch must be placed in the OFF and ON position again between each setting change.
When the automatic door unlock system is deactivated, the doors do not unlock when the ignition switch is placed in the OFF position. To unlock the door manually, use the inside lock knob or the power door lock switch (driver’s or front passenger’s side).
See also:
Warning lights
All-Wheel Drive (AWD) warning light (AWD models) (if so equipped)
The warning light comes on when
the ignition switch is pushed to ON. It turns off soon after the engine is started.
If the AWD ...
Recent Calls
• Incoming
Use the Incoming command to make a call viewing the list of incoming calls.
• Missed
Use the Missed command to make a call viewing the list of missed calls.
• Outgoing
Use the Outgoi ...
Rear-facing child restraint installation using the seat belts
WARNING
► The three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure
to use the ALR mode will result in the
child restr ...
