Seat synchronization function
The selector lever must be in the P (Park) position with the ignition switch in the OFF position.
The entry/exit function can be activated or canceled by pressing and holding the SET switch for more than 10 seconds.
The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pressed for more than 10 seconds to turn on or off the entry/exit function.
The entry/exit function can also be activated or canceled if the “Lift Steering Wheel on Exit” key or “Slide Driver Seat Back on Exit” key is turned to ON or OFF in the “Comfort” settings. (See “Vehicle information and settings”.)
See also:
Getting the spare tire and tools
Jacking tools — Sedan
Jacking tools — Coupe
Spare — Sedan and Coupe
Raise the trunk floor cover 1 using the tab A .
Remove jacking tools located inside the trunk as illustrated.
The spare t ...
Rain-sensing auto wiper system
The rain-sensing auto wiper system can
automatically turn on the wipers and
adjust the wiper speed depending on the
rainfall and the vehicle speed by using the
rain sensor located on the upp ...
Air fresheners
Most air fresheners use a solvent that could affect the vehicle interior. If you use an air freshener, take the following precautions: . Hanging-type air fresheners can cause permanent discoloration w ...