Initialize entry/exit function

Initialize entry/exit function  - Seat synchronization function - Automatic drive positioner (if so equipped) - Pre-driving checks and adjustments - Infiniti G Owners Manual - Infiniti G

If the battery cable is disconnected, or if the fuse opens, the entry/exit function will not work though this function was set on before. In such a case, after connecting the battery or replacing with a new fuse, open and close the driver’s door more than two times after the ignition switch is turned from the ON position to the LOCK position.

The entry/exit function will be activated.

    See also:

    How to handle the sensor
    The sensor for the Preview Function is common with Intelligent Cruise Control and is located below the front bumper. To keep the Preview Function operating properly, be sure to observe the following: ...

    Card holder (if so equipped)
    The card holder is located on or behind the driver’s or passenger’s sun visor. To use the card holder, slide the card in the card holder. ...

    Headlights
    Replacing Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. ...