Bluetooth® Audio player (models with navigation system)
• Some Bluetooth® audio devices may not be recognized by the in-vehicle audio system.
• It is necessary to set up the wireless connection between a compatible Bluetooth ® audio device and the in-vehicle Bluetooth® module before using the Bluetooth® audio player.
• Operating procedure of the Bluetooth® audio player will vary depending on the device. Make sure it is understood how to operate an audio device before using it with this system.
• The Bluetooth® audio player may be stopped under the following conditions:
— Receiving a hands-free call.
— Checking the connection to the hands-free phone.
• Do not place a Bluetooth® audio device in an area surrounded by metal or far away from the in-vehicle Bluetooth® module to prevent tone quality degradation and wireless connection disruption.
• While an audio device is connected through a Bluetooth® wireless connection, the battery power of the device may discharge quicker than usual.
• This system supports the Bluetooth® Audio Distribution Profile (A2DP, AVRCP).
• Wireless LAN (Wi-Fi) and the Bluetooth® functions share the same frequency band (2.4 GHz). Using the Bluetooth® and the wireless LAN functions at the same time may slow down or disconnect the communication and cause undesired noise. It is recommended that you turn off the wireless LAN (Wi- Fi) when using the Bluetooth® functions.
• Bluetooth® is a trademark owned by Bluetooth SIG, Inc. and licensed to Clarion Co., Ltd.
See also:
Accelerator downshift — In D (Drive) position
For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into the lower gear, depending on the vehicle speed. ...
Sensor maintenance
The sensor for the ICC system A is located below the front bumper.
To keep the ICC system operating properly, be sure to observe the following:
● Always keep the sensor clean. Wipe with ...
Off-road recovery
If the right side or left side wheels
unintentionally leave the road surface,
maintain control of the vehicle by following
the procedure below. Please note that this
procedure is only a genera ...