iPod® PLAYER OPERATION (if so equipped)
Connecting iPod®
Open the console lid and connect the iPod® cable to the USB connector. If compatible, the battery of the iPod® is charged while the connection to the vehicle.
Depending on the version of the iPod®, the display on the iPod® shows an INFINITI or Accessory Attached screen when the connection is completed. When the iPod® is connected to the vehicle, the iPod® music library can only be operated by the vehicle audio controls.
* iPod® is a trademark of Apple Inc., registered in the U.S. and other countries.
Compatibility
The following models are available:
Models with navigation system:
• Fifth generation iPod® (version 1.2.3 or later)
• iPod Classic® (version 1.1.1 or later)
• First generation iPod touch® (version 2.0.0 or later)
• Second generation iPod touch® (version 1.2.3 or later)
• First generation iPod nano® (version 1.3.1 or later)
• Second generation iPod nano® (version 1.1.3 or later)
• Third generation iPod nano® (version 1.1 or later)
• Fourth generation iPod nano® (version 1.0.2 or later)
Models without navigation system:
• Fifth generation iPod® (firmware version 1.3)
• First generation iPod Classic® (firmware version 1.1.2 PC)
• Second generation iPod Classic® (firmware version 2.0 PC)
• First generation iPod touch® (firmware version 2.1)
• Second generation iPod touch® (firmware version 2.1.1)
• First generation iPod nano® (firmware version 1.3.1)
• Second generation iPod nano® (firmware version 1.1.3)
• Third generation iPod nano® (firmware version 1.1 PC)
• Third generation iPhone® (firmware version 2.1)
Make sure that the iPod® version is updated.
See also:
Washer operation
To operate the washer, pull the lever
toward the back of the vehicle 5 until
the desired amount of washer fluid is
spread on the windshield. The wiper will
automatically operate several times. ...
Manual Transmission
WARNING
• Do not downshift abruptly on slippery roads. This may cause a loss of control.• Do not over-rev the engine when shifting to a lower gear. This may cause a loss of control or engine damage.
...
Liftgate position setting
The liftgate can be set to open to a specific height by performing the following:
1. Open the liftgate using the request switch or the Intelligent Key.
2. Pull the liftgate down to the desired p ...