Initialization

Initialization  - Using the system - INFINITI Voice Recognition system (models with navigation system) - Monitor, climate, audio, phone and voice recognition systems - Infiniti G Owners Manual - Infiniti G

When the ignition switch is pushed to the ON position, INFINITI Voice Recognition is initialized, which may take up to one minute. When completed, the system is ready to accept voice commands. If the TALK is pushed before the initialization completes, the display will show the message: “System not ready.” or a beep sounds. switch is pushed before the initialization completes, the display will show the message: “System not ready.” or a beep sounds.

    See also:

    Rain-sensing auto wiper system (if so equipped)
    The rain-sensing auto wiper system can automatically turn on the wipers and adjust the wiper speed depending on the rainfall and the vehicle speed by using the rain sensor located on the upper part ...

    Rear display settings
    To adjust the rear display settings, select the preferred key and press the ENTER button. The following settings are available: Aspect: Select the display size from “CINEMA”, “WIDE”, “FULL” or “NOR ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds). ...