Heated front seats (if so equipped)

Heated front seats (if so equipped)  - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

WARNING
Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in body parts that contact the seat. Use of the seat heater by such people could result in serious injury.

CAUTION
● The battery could run down if the seat heater is operated while the engine is not running.
● Do not use the seat heater for extended periods or when no one is using the seat.
● Do not put anything on the seat which insulates heat, such as a blanket, cushion, seat cover, etc. Otherwise, the seat may become overheated.
● Do not place anything hard or heavy on the seat or pierce it with a pin or similar object. This may result in damage to the heater.
● Any liquid spilled on the heated seat should be removed immediately with a dry cloth.
● When cleaning the seat, never use gasoline, benzine, thinner, or any similar materials.
● If any malfunctions are found or the heated seat does not operate, turn the switch off and have the system checked by an INFINITI retailer.

The front seats are warmed by built-in heaters.

The front seats are warmed by built-in heaters.

The switches are located on the center console and can be operated independently of each other.

1. Start the engine.
2. Turn the control knob A to the right 1 and select the desired heat range.

● For high heat, turn the knob to the right 1 .
● For low heat, tun the know to the left 2 .
● The indicator light B will illuminate when the heater is on.

3. To turn off the heater, return the knob to the OFF position 3 . Make sure that the indicator light turns off.

The heater is controlled by a control module, automatically turning the heater on and off.

The indicator light will remain on as long as the switch is on.

When the vehicle’s interior is warmed, or before you leave the vehicle, be sure to turn the switch off.

    See also:

    Front power seat adjustment
    Operating tips ● The power seat motor has an auto-reset overload protection circuit. If the motor stops during operation, wait 30 seconds, then reactivate the switch. ● Do not operat ...

    Control buttons
    Control buttons 1. PHONE SEND button Push the button to initiate a VR session or answer an incoming call. You can also use the button to skip through system feedback and to enter commands during ...

    Seat belts
    The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely before using them. See “Seat belts”. WARNING Do not allow wet seat bel ...