System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
● When the vehicle speed is above 4 MPH (7 km/h).
● When any of the memory switches are pushed while the automatic drive positioner is operating.
● When the adjusting switch for the driver’s seat and steering column is turned on while the automatic drive positioner is operating.
● When the seat has already been moved to the memorized position.
● When no seat position is stored in the memory switch.
● When the shift selector is moved from P (Park) to any other position.
● When the driver’s door remains open more than 45 seconds and the ignition switch is not in the ON position.
● The seat synchronization function is automatically disabled if the outside mirrors or steering wheel reaches its maximum adjustment.
● The seat synchronization function will not operate if the seat is adjusted over one of the following maximum thresholds:
– Seat sliding: 3.0 in (76 mm)
– Seatback reclining: 9.1 degrees
– Seat lifter (rear side): 0.8 in (20 mm) The entry/exit function can be adjusted or canceled through the Vehicle Settings in the vehicle information display by performing the following:
● Switch the Exit Seat Slide from ON to OFF.
● Switch the Exit Steering UP from ON to OFF.
See also:
Heated front seats (if so equipped)
WARNING
Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in body parts that contact the seat. ...
Exhaust gas (carbon monoxide)
WARNING
► Do not breathe exhaust gases; they
contain colorless and odorless carbon
monoxide. Carbon monoxide is dangerous.
It can cause unconsciousness or
death.
► If you susp ...
Audio source switch
Push the audio source switch to change the mode as follows.
Type A:
• Models with navigation system
AM FM
SAT
CD/DVD
Music Box®
USB/iPod®
Bluetooth® Audio
• Models without navigation sy ...