Reprogramming a single HomeLink® button

Reprogramming a single HomeLink® button - HomeLink® Universal Transceiver - Instruments and controls - Infiniti QX Owners Manual - Infiniti QX

To reprogram a HomeLink® Universal Transceiver button, complete the following. 1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed. 2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. 3. Push and hold the hand-held transmitter button. 4. The HomeLink® indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons. The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed. This procedure will not affect any other programmed HomeLink® buttons.

    See also:

    Regulatory information
    FCC Regulatory information ► CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could d ...

    Memory storage
    Two positions for the driver’s seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Automatic transm ...

    Radar maintenance
    The two radar sensors for the BSW, BSI and BCI systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient con ...