Hood
1. Pull the hood lock release handle 1 located below the instrument panel; the hood will then spring up slightly. 2. Pull the lever 2 up at the front of the hood with your fingertips and raise the hood. 3. When closing the hood, slowly close the hood down and make sure it locks into place.
WARNING
► Make sure the hood is completely closed
and latched before driving. Failure to do
so could cause the hood to fly open and
result in an accident.
► If you see steam or smoke coming from
the engine compartment, to avoid injury
do not open the hood.
See also:
Confirming memory storage
● Place the ignition switch in the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approximately 0.5 seconds.
When the memory ...
Engine block heater (if so equipped)
Engine block heaters are used to assist with cold temperature starting.
The engine block heater should be used when the outside temperature is 20°F (27°C) or lower.
WARNING
● Do not use y ...
Changing engine oil and filter
Vehicle set-up
1. Park the vehicle on a level surface and
apply the parking brake.
2. Run the engine until it reaches operating
temperature.
3. Turn the engine off and wait more than
15 min ...