System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
► When the vehicle speed is above 4 MPH
(7 km/h).
► When the adjusting switch for the
driver’s seat and steering column is
turned on while the automatic drive
positioner is operating.
► When the memory switch 1 or 2 is not
pushed for at least 1 second.
► When the seat, steering column and
outside mirrors have already been
moved to the memorized position.
► When no position is stored in the
memory switch.
► When the engine is started while
moving the automatic drive positioner.
► When the AT selector lever is moved
from the P (Park) position to any other
position. (However, it will not be
canceled if the switch is pushed while
the seat and steering column are
returning to the previous positions
(entry/exit function).).
► When the driver’s door remains open
for more than 45 seconds and the
ignition switch is not in the ON position.
See also:
Difference between predicted and actual distances
Backing up on a steep uphill
When backing up the vehicle up a hill, the distance guide lines and the vehicle width guide lines are shown closer than the actual distance.
For example, the display ...
Automatic cancellation
A chime sounds under the following conditions and the control is automatically canceled.
• When the vehicle speed falls below approximately 20 MPH (32 km/h)• When the selector lever is not in the D ( ...
Temperature
A temperature increase will accelerate the rate of corrosion to those parts which are not well ventilated. ...