Replacing
Replace the wiper blades if they are worn. 1. Pull the wiper arm. 2. Push the release tab A , and then move the wiper blade down the wiper arm 1 while pushing the release tab to remove. 3. Insert the new wiper blade onto the wiper arm until a click sounds. 4. Rotate the wiper blade so the dimple is in the groove.
CAUTION
► After wiper blade replacement, return
the wiper arm to its original position;
otherwise it may be damaged when the
hood is opened.
► Make sure the wiper blades contact the
glass; otherwise the arm may be damaged
from wind pressure.
Be careful not to clog the washer nozzle A . This may cause improper windshield washer operation. If the nozzle is clogged, remove any objects with a needle or small pin B . Be careful not to damage the nozzle.
See also:
Fog light switch
To turn the fog lights on, turn the headlight
switch to the position, then turn
the
switch to the position. To turn them
off, turn the switch to the OFF position.
The headlights must be o ...
Top tether anchor point locations
2nd row bench seat
1. Top tether strap
2. Anchor point
3rd row bench seat
Top tether anchor point locations Anchor points are located in the following locations:
● 2nd row bench o ...
HomeLink universal transceiver (Type A) (if so equipped)
The Type A system does not have an IV 1 on the back of the mirror. Move the mirror to see if the IV is present. If the IV is not on the mirror, use the procedure in this section to program the HomeL ...