Automatic moonroof

Automatic moonroof  - Moonroof (if so equipped) - Instruments and controls - Infiniti G Owners Manual - Infiniti G

The moonroof only operates when the ignition switch is in the ON position.

The automatic moonroof is operational for about 45 seconds, even if the ignition switch is pushed to the OFF position. If the drivers door or the passengers door is opened during this period of about 45 seconds, power to the moonroof is canceled.

Sunshade

Sunshade

The sunshade will open automatically when the moonroof is opened. However, it must be closed manually.

Tilting the moonroof

To tilt up, first close the moonroof, then push the UP To tilt down the moonroof, push the DOWN  2 side. 1 side of the moonroof switch and release it; it need not be held.

To tilt down the moonroof, push the DOWN Sliding the moonroof 2 side.

Sliding the moonroof

To fully open or close the moonroof, push the CLOSE 2 side of the moonroof switch and 1 or OPEN release it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch once more while it is opening or closing. 2 side of the moonroof switch and release it; it need not be held. The roof will automatically open or close all the way. To stop the roof, push the switch once more while it is opening or closing.

Auto reverse function

WARNING
There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the moonroof.

If the control unit detects something caught in the moonroof when it is closing, the moonroof will be immediately opened.

The auto reverse function can be activated when the moonroof is closed by automatic operation when the ignition switch is in the ON position or for about 45 seconds after the ignition switch is pushed to the OFF position.

If the moonroof cannot be closed automatically when the auto reverse function activates due to a malfunction, push and hold the CLOSE Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs. 1 side of the moonroof switch.

Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the moonroof occurs.

If the moonroof does not operate

If the moonroof does not operate properly, perform the following procedure to initialize the moonroof operation system.

1. If the moonroof is open, close it fully by repeatedly pushing the CLOSE 2. Push and hold the CLOSE  1 side of the moonroof switch. 1 side of the moonroof switch to tilt the moonroof up.

2. Push and hold the CLOSE 3. Release the moonroof switch after the moonroof moves slightly up and down. 1 side of the moonroof switch.

3. Release the moonroof switch after the moonroof moves slightly up and down.

4. Push and hold the OPEN of the moonroof switch to fully tilt the moonroof down. 2 side of the moonroof switch to fully tilt the moonroof down.

5. Check if the moonroof switch operates normally.

If the moonroof does not operate properly after performing the procedure above, have your vehicle checked by an INFINITI retailer.

    See also:

    Freeing a frozen door lock
    To prevent a door lock from freezing, apply deicer through the key hole. If the lock becomes frozen, heat the key before inserting it into the key hole or use the Intelligent Key system. ...

    Cleaning interior
    Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather surfaces with a clean, soft cloth dampe ...

    LATCH (Lower Anchors and Tethers for CHildren) System
    LATCH system lower anchor locations - bench seat Your vehicle is equipped with special anchor points that are used with LATCH (Lower Anchors and Tethers for CHildren) system compatible child restr ...