Washing
Wash dirt off the vehicle with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, lukewarm (never hot) water.
CAUTION
• Do not use car washes that use acid in the detergent. Some car washes, especially brushless ones, use some acid for cleaning. The acid may react with some plastic vehicle components, causing them to crack. This could affect their appearance, and also could cause them not to function properly. Always check with your car wash to confirm that acid is not used.
• Do not wash the vehicle with strong household soap, strong chemical detergents, gasoline or solvents.
• Do not wash the vehicle in direct sunlight or while the vehicle body is hot, as the surface may become water-spotted.
• Avoid using tight-napped or rough cloths, such as washing mitts. Care must be taken when removing caked-on dirt or other foreign substances so the paint surface is not scratched or damaged.
Rinse the vehicle again with plenty of clean water.
Inside flanges, seams and folds on the doors, hatches and hood are particularly vulnerable to the effects of road salt.
Therefore, these areas must be regularly cleaned. Make sure that the drain holes in the lower edge of the door are open. Spray water under the body and in the wheel wells to loosen the dirt and wash away road salt.
Avoid leaving water spots on the paint surface by using a damp chamois to dry the vehicle.
See also:
Replacing
Replace the wiper blades if they are worn.
1. Pull the wiper arm.
2. Push the release tab A , and then move the wiper blade down the wiper arm
1 while pushing the release tab to remove.
3. Inse ...
Moonroof (if so equipped)
WARNING
• In an accident you could be thrown from the vehicle through an open moonroof.Always use seat belts and child restraints.• Do not allow anyone to stand up or extend any portion of their body ...
Manual operation
Fan speed control:
Turn the “” fan speed control dial
to manually control the fan speed.
Push the “AUTO” button to return to automatic control of the fan speed.
Air recirculation:
Push the intak ...