Clearing the programmed information

Clearing the programmed information - HomeLink universal transceiver (Type A) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

Individual buttons cannot be cleared. However, to clear all programming, press and hold the two outside buttons and release when the indicator light begins to flash (approximately 20 seconds).

    See also:

    Programming HomeLink®
    To program your HomeLink® Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door openers (manu ...

    Vehicle identification number (chassis number)
    The vehicle identification number is located as shown. ...

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution i ...