Operating the HomeLink universal transceiver

Operating the HomeLink universal transceiver - HomeLink universal transceiver (Type B) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

The HomeLink Universal Transceiver, after it is programmed, can be used to activate the programmed device. To operate, simply press and release the appropriate programmed HomeLink Universal Transceiver button. The amber indicator light will illuminate while the signal is being transmitted. For convenience, the hand-held transmitter of the device may also be used at any time.

    See also:

    FCC Regulatory information
    • CAUTION: To maintain compliance with FCC’s RF exposure guidelines, use only the supplied antenna. Unauthorized antenna, modification, or attachments could damage the transmitter and may violate FCC ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...

    Troubleshooting guide
    The system should respond correctly to all voice commands without difficulty. If problems are encountered, try the following solutions. Where the solutions are listed by number, try each solution ...