Programming trouble-diagnosis
If the HomeLink does not quickly learn the handheld transmitter information:
● replace the hand-held transmitter batteries with new batteries.
● position the hand-held transmitter with its battery area facing away from the HomeLink surface.
● press and hold both the HomeLink and hand-held transmitter buttons without interruption.
● position the hand-held transmitter 1 - 3 inches (26 - 76 mm) away from the HomeLink surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink is not programmed within that time, try holding the transmitter in another position – keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the INFINITI Consumer Affairs Department. The phone numbers are located in the Foreword of this manual.
See also:
Environmental factors influence the rate of corrosion
Moisture
Accumulation of sand, dirt and water on
the vehicle body underside can accelerate
corrosion. Wet floor coverings will not dry
completely inside the vehicle, and should
be removed for ...
Liftgate position setting
The liftgate can be set to open to a specific height by performing the following:
1. Open the liftgate using the request switch or the Intelligent Key.
2. Pull the liftgate down to the desired p ...
Clearing the programmed information
Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds). ...