Washing

Washing  - Cleaning exterior - Appearance and care - Infiniti JX Owners Manual - Infiniti JX

Wash dirt off with a wet sponge and plenty of water. Clean the vehicle thoroughly using a mild soap, a special vehicle soap or general purpose dishwashing liquid mixed with clean, lukewarm (never hot) water.

CAUTION
● Do not use car washes that use acid in the detergent. Some car washes, especially brushless ones, use some acid for cleaning. The acid may react with some plastic vehicle components, causing them to crack. This could affect their appearance, and also could cause them not to function properly. Always check with your car wash to confirm that acid is not used.
● Do not wash the vehicle with strong household soap, strong chemical detergents, gasoline or solvents.
● Do not wash the vehicle in direct sunlight or while the vehicle body is hot, as the surface may become water-spotted.
● Avoid using tight-napped or rough cloths, such as washing mitts. Care must be taken when removing caked-on dirt or other foreign substances so the paint surface is not scratched or damaged.

Rinse the vehicle thoroughly with plenty of clean water.

Inside flanges, seams and folds on the doors, hatches and hood are particularly vulnerable to the effects of road salt. Therefore, these areas must be cleaned regularly. Take care that the drain holes in the lower edge of the door are open. Spray water under the body and in the wheel wells to loosen the dirt and wash away road salt.

A damp chamois can be used to dry the vehicle to avoid water spots.

    See also:

    Indicator lights
    Adaptive Front lighting System (AFS) indicator light (if so equipped) When the ignition switch is pushed to the ON position, the Adaptive Front lighting System (AFS) indicator light will ill ...

    System operation
    The automatic drive positioner system will not work or will stop operating under the following conditions: ► When the vehicle speed is above 4 MPH (7 km/h). ► When the adjusting s ...

    Programming HomeLink for Canadian customers and gate openers
    Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink to pick up the signal during trainin ...