Installing top tether strap (2nd row captain’s seats or 2nd row bench seat)
2nd row bench seat
First, secure the child restraint with the LATCH lower anchors (2nd row captain’s or bench outboard seating positions only) or the seat belt, as applicable.
1. If necessary, raise or remove the head
restraint or headrest to position the top
tether strap over the top of the seatback.
If the head restraint or headrest
is removed, store it in a secure place.
Be sure to reinstall the head restraint or
headrest when the child restraint is
removed. See “Head restraints” earlier
in this section and “Headrest” earlier in
this section for head restraint or headrest
adjustment, removal and installation
information.
2. Secure the tether strap to the tether
anchor point on the back of each
seatback behind the child restraint.
3. Tighten the tether strap according to
the manufacturer’s instructions to remove
any slack. Make sure the head
restraint or headrest does not contact
the top tether strap.
If you have any questions when installing
a top tether strap on the rear seat, consult
your INFINITI retailer for details.
See also:
Lane Departure Warning (LDW)/Prevention (LDP) system (if so equipped)
The Lane Departure Warning (LDW) system/
Lane Departure Prevention (LDP) system
will operate when the vehicle is driven
at speeds of approximately 45 MPH (70
km/h) and above, and when it is tr ...
Battery saver system
When all the following conditions are met for 60 minutes, the battery saver system will cut off the power supply to prevent battery discharge.
• The ignition switch is in the ACC position, and• All d ...
Forward-facing child restraint installation using
LATCH
Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint.
Follow these steps to install a forwardfacing child restraint using the L ...